AGRICULTURE BOREWELL PUMP SELECTION INSTRUCTIONS

TO INPUT VALUES TO SELECT SUITABLE PUMP

100 mm (4”) 150 mm (6”) 200 mm (8”)

First select the size of your bore well by clicking the suitable radio

buon.

Enter total depth of the bore well either in feet or in meters in the

respecve input box at “Total Bore Depth in feet or In Meters”. If

entered in feet, it automacally converts and takes only in meters for

calculaon.

Enter the standing water level in the bore well from ground level in feet or

in meters as above at “Stac water level in feet or In meters”.

Next, enter the total water (Struck) got from the bore well at the me of

drilling in LPM only (Litres Per Minute) ranging from 5 to 550 LPM for

Single Phase for 100mm bore and 20 to 1600 LPM for 3 Phase pumps for

150mm bore and 400 to 2000 LPM for 200mm bore Pumps, by measuring

and calculang exactly (Not in V-notch inches or in any other form) at.

“Total Yield (Water) Available in LPM”.

Enter the total height in feet or meters by calculang total head from the

ground level or top of the bore well to the point of delivery of water at

“Height to be pumped from ground level in feet or in Meters”.

Select the available power supply from “Power supply available Single

Phase 230 V Three Phase 415 V”. For above 5 HP pump sets or higher

discharge and head, only 3 phase pumps are available.

Select the required make of the pump set by clicking at the dropdown

menu from.“Which Make Pump Required ” (at present only UNEEL

and Unna brand pumps are available), If not selected any brand, it will

search and display by default from the enre make of pumps for the most

suitable and eﬃcient pump set.

Select the “BACK” buon, in case you go back to the previous page.

Finally select ” ”buon to go to the next address entering the page.